It's time to speak out for your right to repair
A limitation on maximum module size may be enforced by the chipset, the BIOS, or both. Contact the vendor who supplied the DIMM for a replacement.
The general family name near the keyboard or on the frame around the display screen does not provide sufficient information for ordering replacement parts. Common instructions are stored in RAM and can be retrieved in any order to speed up processes.
Or in the Search field at the top of this page, type your product number, a space, and maintenance and service guide Example: Note that some DIMM sockets have minor physical variations. In the notebook specifications document consult the Memory section for the following information.
Fill slot 0 or 1 first, then the other slots sequentially as you add modules. The "dual" part of the name comes from the separate electrical contact points designed on both sides of the module.
The memory self-test should increment up to the newly installed amount of memory. If that occurs, you may need to do one or more of the following things to resolve the problem: For some notebook models where the compartment is under the keyboard, HP recommends contacting an HP authorized support provider for assistance ordering and replacing what slots does ram go into memory.
If this occurs, you may have to set the correct size manually, if indeed the module size you have installed is an available option. Type of memory including speed: The later memory modules had a bit data path, so SIMMs of identical capacity were installed in pairs to synchronize with processors using bit data paths.
In the Maintenance and Service Guide, consult the Memory section for memory module specifications, memory module spare part numbers, compatible processors and types of RAM, and the number of memory slots.
Some motherboards require higher-capacity modules to be installed in lower-numbered slots. There was a notch on both ends of the memory module that was clipped by arms on opposite ends of the slot.
Memory rank Sometimes memory modules are designed with two or more independent sets of DRAM chips connected to the same address and data buses; each such set is called a rank. If it instead shows only the original amount of memory, the cause is almost always that you have not seated the new memory module completely.
For example, if the motherboard has two slots each for channel A and channel B, numbered 0 and 1, fill the slots for channel A slot 0 and channel B slot 0 first. Use the lower of these two numbers as your maximum memory. Find currently installed memory specifications amount, type, maximum supported Consult your notebook specifications or Maintenance and Service Guide for installed memory information.
Check the current amount of memory installed on your computer, and then go to the Verify how much memory you can add section in this document.
Welcome to HP Customer Support
After a memory word is fetched, the memory is typically inaccessible for an extended period of time while the sense amplifiers are charged for access of the next cell. The evolution of RAM technology has resulted in a variety of memory modules. The modules were widely available in pin and pin models with pin models used in proprietary systems.
There would also be one extra chip per group of eight, which is not counted.
The DIMM simply pops out. If the ejector arms are not fully vertical, press them toward the DIMM until they lock into the vertical position, as shown in Figure A few motherboards require smaller modules to be installed in the lower banks. Determine where notebook memory is located The memory module compartment is located on the bottom of most HP and Compaq notebook computers.
Yes, that takes a lot more time, but it's better than destroying the motherboard. ECC modules usually carry a multiple of 9 instead of a multiple of 8 chips. Or in the Search field at the top of this page, type your product number, a space, and either specifications or maintenance and service guide Example: By interleaving the memory e.
When you install a DIMM in a motherboard that's already in the case, pay close attention to how much pressure you're applying.
Modules can be pressed straight into the slot and clipped into place. RQAS maintenance and service guide. Subtract the amount of memory already installed from the maximum amount supported by the system to determine how much memory to purchase. For example, if a single-channel memory motherboard has four memory slots, they will be numbered 0 to 3 or 1 to 4.
If all else fails, the only alternative may be to return the memory module you did make sure you had the right to return an incompatible module, didn't you?
If the DIMM does not fit easily into the socket, do not force it. Power down, reseat the module, and try again. The multiple contact points and the greater number of pins between 72 and allow computers with DIMMs to have greater memory capacity and faster access speed than computers with SIMMs.
If the restriction on module size is enforced by the BIOS but not by the chipset, you may find that a later BIOS revision adds support for the larger module. That rule is not invariable, though.
All other ranks are deactivated for the duration of the operation by having their corresponding CS signals deactivated.